EasyManuals Logo

Oki MC770 Maintenance Manual

Oki MC770
487 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #213 background imageLoading...
Page #213 background image
45584901TH Rev.1
6-22 /
Oki Data CONFIDENTIAL
[C] Replace SRAM board
(1) Confirm that the power is turned OFF.
(2) Take off the Fax Unit (GD-1340) if it is installed.
(3) Replace the SRAM board (for the CU board).
P.6-6“6.1.5SRAMboard<forCUboard>”
[D] Clear SRAM system storage area
(1) TurnthepowerONwhilepressing[6]and[CLEAR]simultaneously.
(2) When“SRAMClearMode”appearsontheLCD,keyin[1]toselect“1.ClearSRAM”
and then press the [START] button.
(3) When“SRAMFormatCompleted”isdisplayedontheLCD,initializingiscompleted.
(4) Turn the power OFF.
[E] Restore SRAM
IfthereisSRAMbackupdata,performthefollowingsteps.
(1) TurnthepowerONwhilepressing[6]andthe[CLEAR]buttonsimultaneously.
(2) When“SRAMClearMode”appearsontheLCD,keyin[0]toselect“0.SetSerial
Number” and then press the [START] button.
(3) Keyintheserialnumberonthelabelattachedtotherearcoveroftheequipment,and
thenpressthe[OK]button.
(4) “SerialNumberSettingcompleted”isdisplayed.
(5) Turn the power OFF.
(6) InstalltheUSBdeviceintheequipment,andthenturnthepowerONwhilepressing[5]
and [9] simultaneously.
(7) Keyin[2]toselect“2.RestoreSRAMDatafromUSB”andthenpressthe[START]
button.
(8) Enter the password set for the backup data.
(9) Enter the serial number of the backup file.
(10) Turn the power OFF after the restoring of SRAM is completed.
Remarks:
When the restoration is completed successfully, do not perform“[F] Clear SRAM
updateerrorags”orlaterprocedures.
End this procedure here and finish replacing the SRAM board (for CU board).
(11) Reinstall the Fax Unit (GD-1340) if used.
[F] Clear SRAM update Error flags
(1)TurnthepowerONwhilepressing[3]andthe[CLEAR]buttonsimultaneously.
(2) Enterthepassword,andthenpressthe[OK]button.(Ifthepasswordisnotsetfor
Service,pressthe[ENTER]buttonwithoutenteringanything.)
(3)After“FirmwareAssistMode”isdisplayedontheLCD,checkthat“1:ClearErrorFlag
in Software Installation.” is marked and press the [START] button.
Ifnot,keyin[1]andthenpressthe[START]button.
(4) When“OperationComplete”isdisplayedontheLCD,clearingtheagiscompleted.
(5) Turn the power OFF.

Table of Contents

Other manuals for Oki MC770

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Oki MC770 and is the answer not in the manual?

Oki MC770 Specifications

General IconGeneral
BrandOki
ModelMC770
CategoryAll in One Printer
LanguageEnglish

Related product manuals