45584901TH Rev.1
8-14 /
Oki Data CONFIDENTIAL
Important:
• OnlytheUSBdeviceswhichmeetthefollowingconditionsshouldbeusedforupdating.Be
careful since updating with any device other than the above is never guaranteed.
- AcombinationUSBdevicewithaashmemory(tobeconnecteddirectlytotheUSBport)
and its capacity is 1GB or more.
- Operation of the USB device used for updating has been confirmed at the input check of
thisequipment(Testmode03).(
P.3-7“3.3Inputcheck(Testmode03)”)
- USB devices which comply with the following standards regulated by USB-IF (USB
Implementers Forum)
Classnumber: 8(=08h)(Mass-storageclass)
Sub-classnumber: 6(=06h)(SCSItransfercommandset)
Protocolnumber: 80(=50h)(Bulk-Only)
* Most common USB devices comply with the specification above and can be used for
updating.However,theoperationinalltheMultiFunctionalDigitalColorSystemsand
Multi Functional Digital Systems is not necessarily guaranteed since the most of these
devices are developed based on use in a PC environment (Windowsor Macintosh).
Therefore,checkthoroughlythat thedeviceisoperational intheequipmentforwhich
the updating will be performed when purchasing it.
• TheUSBdevicescomplyingwithUSB2.0canbeusedforupdating.
• Do not update the rmware byany storagedeviceotherthan a ash memory (such as a
USB connection type memory card reader, CD/DVD drive or hard disk), since it is never
guaranteed.
• Itispossibletostorethe model specific updateprogramand the datafileforupdating
directly in the root directory when you store the updating data file for one specific model in
theUSBdevice.However,ifthemodelspecicfolderforthesamemodelasthatofthedata
lestoredintherootdirectoryalreadyexists,thiswillhavepriority.
To Next Page
Loading...
