Oki MC770 - Page 418

45584901TH Rev.1
11-115 /
Oki Data CONFIDENTIAL
05/08 Mode Element
Sub
element
Item Subitem Code
Sub-
code
Details
Default
value
Acceptable
value
RAM Contents
Proce-
dure
08 Setting
Mode
System User
interface
Service notification
information
8715 Password for zip file
with password
#10481
09
- SYS Password for zip file with password of service notification
information.
Minimumnumberofdigits:0,maximumnumberofdigits:
20
Available character: alphanumeric characters and
symbols
11
08 Setting
Mode
System General 8717 Shutdown when
SLEEPisenabled
0 0-1 SYS Sets the operation when the power button is pressed for
afewsecondsifSLEEPisenabled.
0:Hibernation1:SLEEP
1
08 Setting
Mode
System User
interface
8718 Selection for
caching the screen
of control panel at
start-up
0 0-17 SYS Use this code to shorten the time to switch the function
on the control panel for the first time immediately after
start-up.However,thestart-uptimebecomeslonger
(about1to3secondsperscreen).Whenselecting
multiplescreens,enterthetotalvalue.
0: Disabled
1: Copy
16: Fax
1
08 Setting
Mode
System Network 8719 MTU setting
of network
communication
1500 576-1500 NIC Normally there's no need to change the MTU value.
However,settheproperMTUvaluewhenMFPis
connected to the Internet using broadband router and so
on.
12
08 Setting
Mode
System User
interface
8720 Department code
display with asterisk
0 0-1 SYS 0: Displays department code with asterisk when inputting
it.
1: Displays department code as it is when inputting it.
1
08 Setting
Mode
System FAX 8721 AutomaticFAX
sending at
AutoClear when
scanning original
put on the glass
0 0-1 SYS Sets whether the job is sent or canceled when AutoClear
is executed on the interruption screen to confirm the next
original displayed after scanning the original put on the
glass.Usethiscodetocanceljobwhentheequipmentis
left unattended while the interruption screen is displayed.
0: Sends job
1: Cancels job
1
08 Setting
Mode
System User
interface
8722 Display method of
"Cannot find the
Home Directory" on
the control panel
0 0-1 SYS Sets the display method of error if the Home Directory
for user cannot be obtained from the server when
setting the Home Directory for scanning. Use this code
to disable the pop-up display when the Home Directory
cannot be obtained depending on the user.
0: Displays the pop-up dialogue when user logs in
1: Displays the message in the guidance area when the
Scan to File screen is displayed
1
08 Setting
Mode
System User
interface
8723 Pop-up display
of logging out of
user authentication
and department
management on the
control panel
1 0-1 SYS Sets whether the pop-up dialog of confirmation for
logging out is displayed when user or department
logs out by pressing [RESET] button twice or pressing
[AUTHENTICATION] button.
0:Logsoutwithoutdisplayingpop-updialog
1: Displays pop-up dialog when logging out
1