26
Communication Menu Configuration
90
MODE
Press ‘RESET/ENTER’ 26) Display shows "StOREd" stored message momentarily and then
advances to the "MOdE" Data Flow Mode submenu.
• Data Flow Mode determines whether the instrument will wait for
commands and data requests from Serial Bus- as defined as
“COMMNd" Command Mode or will send data automatically and
continuously to the Serial Bus-as differently defined as "CONt IN"
Continuous Mode.
• Devices configured for the RS-485 Communication Standard operate
properly only under Command Mode.
Press ‘RESET/ENTER’ 27) Display flashes "COMMNd" Command Mode as default or previous
selection.
Press ‘䊱/MAX’ 28) Scroll and select either only two available Modes "COMMNd"
Command Mode or "CONt IN" Continuous Mode for your choice of setting.
HNd.SHk
Press ‘RESET/ENTER’ 29) Display shows "StOREd" stored message momentarily and then
advances to the "HNd.SHk" Hand Shake Method submenu.
• Message Hand Shake: The RTS (Request To Send) line from the host
controller is checked when the device is ready to send measurement
data. If the RTS is true, it sends the complete message data without
interruption even if RTS goes false in the middle of transmission. If
RTS is false, it skips sending the data completely and continues with
the next measurement.
• Character Hand shake: The device checks the RTS input before
sending each character and sends characters only while RTS is true. It
always completes sending the data before transferring the latest
reading to the output buffer.
• No RTS handshaking is available with Multi-point Operation Class.
Press ‘RESET/ENTER’ 30) Display flashes "MESSAG" Message Hand Shake Method as default
or previous selection.
Press ‘䊱/MAX’ 31) Scroll or Select either only two following methods "MESSAG" Message
Hand Shake or "CHAR" Character Hand Shake for your choice of setting.
Press ‘RESET/ENTER’ 32) Display shows "StOREd" stored message momentarily and then
advances to the "dAt.FMt" Data Format Configuration Submenu.
To Next Page
Loading...
Need help?
General
