Omega DP41-B - Flashing Messgaes; Thermocouple Table; Table 33-2 ITS 90 Thermocouple Tables

113
Specifications
33
33.7 FLASHING MESSAGES:
DURING PROGRAMMING (CONFIGURATION MODE)
NUMERICAL OVERFLOW: “999999”
OFFSET OVERFLOW: “ERR 01”
SETPOINT OVERFLOW: “ERR 02”
NOT STORED IN EEPROM: “NOSTOR”
VALUE PUT IN EEPROM: “STORED”
DURING MEASUREMENT (RUN MODE)
INPUT TOO LARGE, POS I TIVE: “OVLD”
INPUT TOO LARGE, NEG A TIVE: “– OVLD”
INPUT OUT OF RANGE, POSITIVE: “OPEN”
INPUT OUT OF RANGE, NEGATIVE: “– OPEN”
EXCESS INPUT SCALE/OFF SET: “I OVSC”
EXCESS DISPLAY SCALE/OFFSET: “R OVSC”
COUNT-BY DISPLAY OVER FLOW: “999999”
DURING SETPOINT ADJUST (RUN MODE)
OUT OF SELECTED DIGIT RANGE: “999999”
NOT STORED IN EEPROM: “NOSTOR”
VALUE PUT IN EEPROM: “STORED”
33.8 ITS-90 THERMOCOUPLE TABLES
For complete Thermocouple Tables, please refer to the Technical Reference Section :
Thermocouple Reference Data.
This information is located:
http://omega.com/temperature/Z
Temperature Handbooks, Section Z
or
CD-ROM, enclosed with your shipment