99
Lockout (Access Security) Configuration Menu
30
30 LOCKOUT (ACCESS SECURITY) CONFIGURATION MENU
• To prevent unauthorized tampering with the setup parameters, this instrument provides protection
by requiring the user to enter the ID (Access Security) Code before allowing access any locked
menu item on Main menu.
• The locked menu will be skipped and invisible during Menu Navigation, however Display will show
the locked setpoint and value but editing mode is disabled (first digit is not flashing).
•
Whether multiple or single menu accessibility/restriction desired, there is only one ID code needed.
LCk.CNF
ENTER LOCKOUT (ACCESS SECURITY) CONFIGURATION MENU:
Press ‘MENU’ 1) Ten times, Display shows "LCk.CNF" Lockout (Access Security)
Configuration Menu.
Press ‘RESET/ENTER’ 2) Display shows "Id" Access Security ID menu.
Press ‘RESET/ENTER’ 3) Display shows 4 numbers 0 (0000) with the first digit flashing.
Press ‘䊱/MAX’ & ‘
䊳
/MIN’ 4) To enter Access Security ID code.
• The default code is any 4-digit number that has the sum of its 4 digits
equal 10. For example 1234 is one of the default ID code since
1+2+3+4 = 10.
• Use numbers that are easy for you to remember. If the ID Code is
forgotten or lost, Call customer service with your serial number to
access and reset to the default ID code.
Press ‘RESET/ENTER’ 5) Display shows "CHNG. Id" Change ID Code menu; which Implies that
the ID code, was just entered, is accepted otherwise the meter will return
to “Id" ID Code menu and allows user enter the ID code again if the correct
ID code still is not found for over 3 attempts then display shows "ERROR"
and advances to "RUN" Run mode.
Press ‘RESET/ENTER’ 6) Display shows 4 numbers 0 (0
000) with the first digit flashing.
Press ‘䊱/MAX’ & ‘
䊳
/MIN’ 7) To modify and enter new ID code if necessary, otherwise skip this
menu by Press ‘RESET/ENTER’ again.
To Next Page
Loading...
Need help?
General
