Omron CP1L - Page 106

72
Specifications Section 2-2
Transistor Outputs (Sinking or Sourcing)
Note (1) The fuse cannot be replaced by the user.
(2) If the ambient temperature is maintained below 50°C, up to 0.9 A/com-
mon can be used.
!Caution Do not connect a load to an output terminal or apply a voltage in excess of the
maximum switching capacity.
Item Specification
CP1W-40EDT
CPM1A-40EDT
CP1W-40EDT1
CPM1A-40EDT1
CP1W-32ET
CP1W-32ET1
CP1W-20EDT
CPM1A-20EDT
CP1W-20EDT1
CPM1A-20EDT1
CP1W-16ET
CP1W-16ET1
CP1W-8ET
CPM1A-8ET
CP1W-8ET1
CPM1A-8ET1
Max. switching
capacity
(See note2.)
4.5 to 30 VDC
0.3 A/output
4.5 to 30 VDC
0.3 A/output
24 VDC
10%
/
−5%
0.3 A/output
4.5 to 30 VDC
0.3 A/output
• OUT00/01 4.5 to
30 VDC, 0.2 A/
output
• OUT02 to 07 4.5
to 30 VDC, 0.3
A/output
0.9 A/common
3.6 A/Unit
0.9 A/common
7.2 A/Unit
0.9 A/common
1.8 A/Unit
0.9 A/common
3.6 A/Unit
0.9 A/common
1.8 A/Unit
Leakage current 0.1 mA max. 0.1 mA max. 0.1 mA max. 0.1 mA max. 0.1 mA max.
Residual voltage 1.5 V max. 1.5 V max. 1.5 V max. 1.5 V max. 1.5 V max.
ON delay 0.1 ms max. 0.1 ms max. 0.1 ms. 0.1 ms max. 0.1 ms max.
OFF delay 1 ms max.
24 VDC
+10%
/
−5%
5 to 300 mA
1 ms max.
24 VDC
+10%
/
−5%
5 to 300 mA
1 ms max.
24 VDC
+10%
/
−5%
5 to 300 mA
1 ms max.
24 VDC
+10%
/
−5%
5 to 300 mA
1 ms max.
24 VDC
+10%
/
−5%
5 to 300 mA
Max. number of
Simultaneously
ON Points of Output
16 pts (100%) 24 pts (75%) 8 pts (100%) 16 pts (100%) 8 pts (100%)
Fuse (See note 1.) 1 fuse/common
Circuit configuration
COM (−)
OUT
OUT
L
L
COM (+)
OUT
OUT
L
L
Sinking Outputs Sourcing Outputs
Output LED
Output LED
Internal
circuits
Internal
circuits
24 VDC/4.5
to 30 VDC
24 VDC/4.5
to 30 VDC
0.9
0.8
(A)
0
(°C)
50 55
Ambient tem
p
erature
Total current for common