Omron CP1L - Connecting the CX-Programmer

23
Connecting the CX-Programmer Section 1-3
Using CP1W-8ER/16ER/20EDR1/32ER/40EDR or
CPM1A-8ER/16ER/20EDR1/40EDR Expansion I/O Units with
CPU Units with Transistor Outputs (CP1L-@@@DT@-D)
Relay Output Load Current Derating Curves for Expansion I/O Units
Note There are no restrictions on the transistor output load current from the CPU
Unit.
CPU Units with AC Power
There are no restrictions on the output load current from CPU Units with AC
power.
1-3 Connecting the CX-Programmer
The CX-Programmer (version 7.3 or higher), which runs on Windows, can be
used with CP-series CP1L L model PLCs with 10 I/O points. The CX-Pro-
grammer (Version 7.22 or higher), which runs on Windows, can be used in
CP-series CP1L J model PLCs. The CX-Programmer (version 7.1 or higher),
which runs on Windows, can be used with CP-series CP1L L or M model
PLCs with 14, 20, 30, 40 or 60 I/O points. Computers running Support Soft-
ware (e.g., the CX-Programmer) can be connected to the USB port or to a
serial port.
Note A Programming Console cannot be used with CP1L PLCs.
Expansion I/O Units added
to the
CP1L-L14DT@-D or
CP1L-L20DT@-D
CP1L-J14DT@-D or
CP1L-J20DT@-D
Expansion I/O Units added
to the
CP1L-M30DT@-D
Expansion I/O Units added
to the
CP1L-M40DT@-D or
CP1L-M60DT@-D
50%
100%
55
°
C
40 45
0%
Power voltage:
20.4 VDC
Power voltage:
21.6 VDC
Ambient temperature
50%
100%
55
°C
4535
0%
Power voltage:
20.4 VDC
Power voltage:
21.6 VDC
Ambient temperature
50%
100%
55
°
C
4535
0%
Power voltage:
20.4 VDC
Power voltage:
21.6 VDC
Ambient temperatur
e