Omron CP1L - Connecting with a Commercially Available USB Cable

24
Connecting the CX-Programmer Section 1-3
1-3-1 Connecting with a Commercially Available USB Cable
Connect the computer running the CX-One Support Software (e.g., the CX-
Programmer) using a commercially available USB cable to the peripheral USB
port on the CPU Unit.
Restrictions when
Connecting by USB
In conformity with USB specifications, the following restrictions apply when
connecting a computer running Support Software.
• A USB connection is possible for only one CP-series PLC from a single
computer. It is not possible to connect multiple PLCs simultaneously.
• Do not disconnect the USB cable while the Support Software is con-
nected online. Before disconnecting the USB cable, be sure to place the
application in offline status. If the USB cable is disconnected while online,
the situations described below will occur as a result of OS error.
• Windows Me, 2000, or XP:
The Support Software cannot be returned to online status by simply re-
connecting the USB cable. First return the Support Software to offline
status, and then reconnect the USB cable. Then perform the online
connection procedure for the Support Software.
• Windows 98:
If the USB cable is disconnected while online, an error message may
be displayed on a blue screen. If that occurs, it will be necessary to re-
boot the computer.
The peripheral USB port (conforming to USB 1.1, B connector) is a dedicated
port for connecting Support Software, such as the CX-Programmer.
Items Required for USB Connection
Installing the USB Driver The procedure for first connecting a computer to the CP1L peripheral USB
port is described below.
It is assumed that the Support Software has already been installed in the
computer.
Windows XP
Turn ON the power supply to the CP1L, and connect USB cable between the
USB port of the computer and the peripheral USB port of the CP1L.
Personal computer
CX-One (CX-Programmer, etc.)
USB port
USB cable
Peripheral
USB port
Operating system Windows 98, Me, 2000, or XP
Support Software CX-Programmer Ver. 6.1 (CX-One Ver. 1.1)
USB driver Included with above Support Software.
USB cable USB 1.1(or 2.0) cable (A connector-B connector), 5 m max.