502
LCD Option Board Function Section 8-6
8-6-2 PLC Mode
This function can display the present PLC mode and change the PLC mode.
Example Change the PLC Mode from RUN to PRG.
1,2,3...
1. Switch to the Setup Mode.
2. Press the OK button to enter the Mode Screen.
There is a choice of 3 PLC modes-RUN/MON/PRG.
The line cursor will point to the present PLC mode.
The present mode is
RUN
.
3. Press the Down button to select
PROGRAM
.
4. Press the OK button, then LCD will update the present mode to
PRG
.
To Next Page
Loading...
