Omron CP1L - Page 221

187
High-speed Counters Section 5-1
Input Terminal Arrangement for CPU Units with 40 I/O Points
Input Terminal Arrangement for CPU Units with 60 I/O Points
Input Function Settings in the PLC Setup
The CPU Unit’s built-in inputs can be set for use as high-speed counter inputs
in the PLC Setup’s Built-in Input Tab using the CX-Programmer. (When an
input is set for use as a high-speed counter input, the corresponding words
and bits cannot be used for general-purpose (normal) inputs, input interrupts,
or quick-response inputs.)
CPU Units with 10 I/O Points
CO ML1 L2/N 01
00 02 04
03 05 07
06
09
08
11
10
01 03 05 07 09 11
00 02 04 06 08 10
High-speed counter 1
(Phase Z or Reset input)
High-speed counter 3
(Increment)
Upper Terminal Block
(Example: AC Power
Supply Modules)
High-speed counter 1
(Increment)
High-speed counter 0
(Increment)
High-speed counter 2
(Increment)
High-speed counter 3
(Phase Z or Reset input)
High-speed counter 2
(Phase Z or Reset input)
High-speed counter 0
(Phase Z or Reset input)
High-speed counter 0
(Increment)
High-speed counter 1
(Increment)
High-speed counter 2
(Increment)
High-speed counter 3
(Increment)
High-speed counter 0
(Phase Z or Reset input)
High-speed counter 1
(Phase Z or Reset input)
High-speed counter 3
(Phase Z or Reset input)
High-speed counter 2
(Phase Z or Reset input)
L2/N L1 COM 01 03 05 07 09 11 01 03 05 07 09 11 01 03 05 07 09 11
00 02 04 06 08 10 00 02 04 06 08 10 00 02 04 06 08 10
Upper Terminal Block
(Example: AC Power
Supply Modules)
Address Default setting High-speed counter operation settings Origin searches
Word Bit Single-phase
(increment pulse input)
Two-phase (differential
phases x4, up/down, or
pulse/direction)
Origin searches
enabled for pulse
outputs 0
CIO 0 00 Normal input 0 Counter 0, increment input Counter 0, A phase, up, or
count input
---
01 Normal input 1 Counter 1, increment input Counter 0, B phase, down,
or direction input
---
02 Normal input 2 Counter 2, increment input Counter 1, A phase, up, or
count input
---
03 Normal input 3 Counter 3, increment input Counter 1, B phase, down,
or direction input
Pulse output 0:
Origin proximity input
signal
04 Normal input 4 Counter 0, phase-Z/reset
input
Counter 0, phase-Z reset
input
---
05 Normal input 5 Counter 1, phase-Z reset
input
Counter 1, phase-Z reset
input
Pulse output 0:
Origin input signal