292
Inverter Positioning Section 5-3
PULSE OUTPUT:
PLS2(887)
PLS2(887) outputs a specified number of pulses to the specified port. Pulse
output starts at a specified startup frequency, accelerates to the target fre-
quency at a specified acceleration rate, decelerates at the specified decelera-
tion rate, and stops at approximately the same frequency as the startup
frequency. Only independent mode positioning is supported.
PLS2(887) can also be executed during pulse output to change the number of
output pulses, target frequency, acceleration rate, or deceleration rate.
PLS2(887) can thus be used for sloped speed changes with different acceler-
ation and deceleration rates, target position changes, target and speed
changes, or direction changes.
Operand Description
P Port specifier 0020 hex: Inverter positioning 0
0021 hex: Inverter positioning 1
M Output mode Bits 0 to 3 Mode
1 hex: Independent
Bits 4 to 7 Direction
0 hex: CW
1 hex: CCW
Bits 8 to 11 Not used: Always set to 0 hex.
Bits 9 to 15 Not used: Always set to 0 hex.
SFirst word of
settings table
S Acceleration/Deceleration Rate
1 to 65,535 Hz (0001 to FFFF hex)
S+1 (lower 4
digits)
Target Frequency in Hz
Pulse output 0 to 3: 0000 0000 to 0001 86A0
hex (0 to 100 kHz)
J models: 0000 0000 to 0000 4E20 hex
(0 to 20kHz)
S+2 (upper 4
digits)
ACC(888)
M: Output mode
P: Port specifier
S: First word of settings table
P
M
S
Operand Description
P Port specifier 0020 hex: Inverter positioning 0
0021 hex: Inverter positioning 1
M Output mode Bits 0 to 3 Mode
0 hex: Relative pulses
1 hex: Absolute pulses
Bits 4 to 7 Direction
0 hex: CW
1 hex: CCW
Bits 8 to 11 Not used: Always set to 0 hex.
Bits 9 to 15 Not used: Always set to 0 hex.
PLS2(887)
P
M
S
F
M: Output mode
P: Port specifier
S: First word of settings table
F: First word of starting frequency
To Next Page
Loading...
