Omron CP1L - Page 64

30
Connecting the CX-Programmer Section 1-3
2. Click the OK Button to finish setting the PLC model. Then connect to the
CP1L by executing the CX-Programmer's online connection command.
Checking after Installation
1,2,3... 1. Display the Device Manager at the computer.
2. Click
USB (Universal Serial Bus) Controller , and confirm that OMRON
SYSMAC PLC Device
is displayed.
Re-installing the USB
Driver
If the USB driver installation fails for some reason or is cancelled in progress,
the USB driver must be reinstalled.
Checking USB Driver Status
1,2,3... 1. Display the Device Manager on the computer.
2. If
USB Device is displayed for Other devices , it means that the USB driver
installation has failed.