192
Chapter7 Accessories (Sold Separately)
F3SJ-A
User’s Manual
Appendix
PC tool for F3SJ
Key cap for muting
Spatter protection cover (2 cables per set, common for emitter/receiver)
Protect bar (1 set, common for emitter/receiver)
Protection bracket for protect bar (4)
Appearance Model name Note
F39-GWUM CD-ROM (SD Manager), branch connector, connector cap,
dedicated cable, and dedicated cable with plug are provided.
Appearance Model name Note
F39-CN6 Case color: Orange
Can be used for emitter and receiver
Appearance Model name Note
F39-HJ In this table, the in the model indicates the same 4-digit
number as the protective height ( in the model) of the
F3SJ.When a spatter-proof cover is attached, operating range of
F3SJ is reduced by about 10%.Spatter-proof cover with 1970 or
higher of in the model is divided into 2 in combination to
use.
Appearance Model name Note
F39-PJ-S One protect bar is provided in a set (common for emitter/
receiver). If both of an emitter and a receiver need a
protect bar respectively, you must purchase 2 sets. For
side mounting of F3SJ with a width of 1001mm or wider,
you must purchase protection bracket (4) for protect bar
(F39-PJ-MS).
Appearance Model name Note
F39-PJ-MS Intermediate mounting bracket for side mounting using a
protect bar. You must purchase 1 set for F3SJ with
protective height from 1001 to 2000mm, or 2 sets for
F3SJ with protective height of 2009 to 2495mm.
To Next Page
Loading...
Need help?
General
