99
4-7-5 Program Searches
The
program can be searched for occurrences of any designated instruction or
data
area address used in an instruction. Searches can be performed from any
currently displayed address or from a cleared display.
To
designate a bit address, press SHIFT
, press CONT/#, then input the address,
including
any data area designation required, and press SRCH. T
o designate an
instruction, input the instruction just as when inputting the program and press
SRCH.
Once an occurrence of an instruction or bit address has been found, any
additional occurrences of the same instruction or bit can be found by pressing
SRCH again. SRCH’G will be displayed while a search is in progress.
When
the first word of a multiword instruction is displayed for
a search operation,
the
other words of the instruction can be displayed by pressing the down key be
-
fore continuing the search.
If
Program Memory is read in RUN or MONIT
OR mode, the ON/OFF status
of
any bit displayed will also be shown.
Key Sequence
Inputting, Modifying, and Checking the Program Section 4-7
To Next Page
Loading...
Need help?
General
