389
Note The data inside the Memory Cassette should be protected by turning on the
write-protect switch whenever you are not planning to write to the Cassette.
Writing Data The
following procedure is used to write IOM data from the C200HS
CPU to a
Memory Cassette mounted in the CPU.
1, 2, 3... 1. Turn
of
f the write-protect switch on the
Memory Cassette to write-enable it.
2. Make sure that power to the C200HS CPU is turned OFF.
3. Mount the Memory Cassette to the CPU.
4. Turn on the CPU.
5. Switch the C200HS to PROGRAM mode.
6. Turn
ON SR 27300 from the LSS or a Programming Console. The IOM data
will
be written to the Memory
Card and SR 27300 will be turned OFF auto
-
matically.
Reading Data The
following procedures are used to read IOM data from a Memory Cassette
mounted
in the C200HS CPU to the CPU. This data cannot be read out automat
-
ically
at startup and must be read manually
. Also, the error log
in DM 6000 to DM
6030 cannot be read with this procedure.
1, 2, 3... 1. Make sure that power to the C200HS CPU is turned OFF.
2. Mount a Memory Cassette to the CPU.
3. Turn on the CPU.
4. Switch the C200HS to PROGRAM mode.
5. Turn
ON SR 27301 from the LSS or a Programming Console. The IOM data
in
the Memory Cassette will be read to the CPU and SR 27301 will be turned
OFF automatically.
IOM Area Data Section 9-4
To Next Page
Loading...
Need help?
General
