237
Example In
the following example, the content of
IR 040 is set to #0000 and then increm
-
ented by 1 each cycle. For the first two cycles, AVG(––) moves the content of
IR 040 to DM 1002 and DM 1003. The contents of DM 1001 will also change
(which
can be used to confirm that the results of
A
VG(––) has changed). On the
third and later cycles AVG(––) calculates the average value of the contents of
DM 1002 to DM 1004 and writes that average value to DM 1000.
@MOV(21)
040
#0000
00001
Address Instruction Operands
00000 LD 00001
00001 @MOV(21)
# 0000
040
00002 AVG(––)
040
# 0003
DM 1000
00003 CLC(41)
00004 ADB(50)
040
# 0001
040
AVG(––)
#0003
040
DM 1000
CLC(41)
ADB(50)
#0001
040
040
1
st
cycle 2
nd
cycle 3
rd
cycle 4
th
cycle
DM 1000
0000 0001 0001 0002 Average
DM 1001
0001 0002 8000 8000 Pointer
DM 1002
0000 0000 0000 0003 Previous
DM 1003
--- 0001 0001 0001
values of
DM 1004
--- --- 0002 0002
IR 40
1
st
cycle 2
nd
cycle 3
rd
cycle 4
th
cycle
IR 40
0000 0001 0002 0003
5-21-4 SUM – SUM(––)
C: Control data
IR, SR, AR, DM, HR, LR
R
1
: First word in range
IR, SR, AR, DM, HR, TC, LR
Ladder Symbols
Operand Data Areas
D: First destination word
IR, SR, AR, DM, HR, LR
SUM(––)
C
R
1
D
@SUM(––)
C
R
1
D
Limitations The 3 rightmost digits of C must be BCD between 001 and 999.
If
bit 14 of C is OFF (setting for BCD data), all data within the range R
1
to R
1
+N–1
must be BCD.
Special Math Instructions Section 5-21
To Next Page
Loading...
Need help?
General
