427
Parameters Program (Response)
The program is read from the entire program area.
Note To stop this operation in progress, execute the ABORT (XZ) command.
11-3-31 PROGRAM WRITE –– WP
Writes
to the PC user
’
s program
area the machine language (object code) pro
-
gram
transmitted from the host computer
. The contents are written as a block,
from the beginning.
Command Format
@ WP
x
10
0
x 10
1
x 16
1
x 16
0
↵:
Node no.
Header
code
1 byte
Program (Up to maximum memory size)
TerminatorFCS
Response Format
@ WP
x
10
0
x 10
1
x 16
1
x 16
0
↵:
Node no.
Header
code
End code
TerminatorFCS
Parameters Program ((Command)
Program data up to the maximum memory size.
11-3-32 I/O TABLE GENERATE –– MI
Corrects the registered I/O table to match the actual I/O table.
Command Format
@ MI
x
10
0
x 10
1
↵:
Node no.
Header
code
TerminatorFCS
Response Format
@ MI
x
10
0
x 10
1
x 16
1
x 16
0
↵:
Node no.
Header
code
End code
TerminatorFCS
11-3-33 COMPOUND COMMAND –– QQ
Registers
at the PC all of the bits, words, and timers/counters that are to be read,
and reads the status of all of them as a batch.
Registering Read Information
Register
the information
on all of the bits, words, and timers/counters that are to
be read.
Host Link Commands
Section 11-3
To Next Page
Loading...
