Omron SYSMAC C200HS

Revision History
501
Revision
code
Revised contentDate
2B July 1995 The following corrections and additions were made.
Page 6: SYSMAC Support Software added and LSS removed.
Pages 23 and 374: Default communications parameters changed.
Page 26: I/O Terminals and B7A Interface Unit added and macro bits corrected.
Page 31: List of Units that don’t use slot words corrected.
Pages 32, 33, 34, 39, 43, 48, 50: Group-2 B7A Interface Units and I/O Terminals
added.
Page 39: Type of data stored in SR 25108 to SR 25115 corrected to BCD.
Page 44: Section added on Special Unit Error Flag
Pages 45, 46: Mode for SR 26408 to SR 26415 changed.
Page 48: Details added to first table.
Page 52: Heading shortened.
Page 120: Caution added.
Pages 215, 216: Limits for operands clarified/corrected.
Page 243: Caution added.
Pages 243, 244: Variable name changed for Y and corrected variable description.
Page 245: Bottom graphic and related description corrected.
Page 274: Explanation in last paragraph clarified.
Page 283: Execution time corrected for IORF(97).
Pages 299 to 301: CPU models specified in control word contents corrected.
Page 314: Graphic corrected.
Page 336: Description of Host Link Systems expanded.
Page 382: Last argument corrected in application example
Page 405: Top graphic corrected and “frame 2” changed to “frame 3” in second
graphic.
Page 461: Default added for DM 6610 and DM 6618.
Page 462: Settings for DM 6620 bits 00 to 09 and DM 6621 bit 08 to 15 corrected.
Page 463: Default for DM 6654 bits 00 to 07 changed.
2C August 1996 The Precautions section was added after About this Manual.
Page 88: Special I/O Unit type “N” corrected from Host Link Unit to Position Control
Unit.
Page 110: Ladder diagram corrected for the self-maintaining bit example.
Page 158: ASFT(17) example changed.
Page 191: “Content of the source words is zero” corrected to “Content of a source
word is zero” for the ER Flags.
Page 226: DVB(53) example changed.
Page 280: “SR” added to the first source word of LMSG(47).
Page 395: “Possible correction” for “I/O bus error” corrected.
Page 430: “Command Format” corrected to “Response Format” for 11-3-36 Unde-
fined Command –– IC.
3 May 1999 Page 245: Proportional operation diagram corrected.
Page 283: Note and execution time information in 5-25-8 I/O REFRESH – IORF(97)
corrected.
Page 321: C200H-PIDjj
added to Special I/O Unit Refresh.
4 April 2001 Page xv: Minor change made to precautionary information on mounting.
Page 23: Information on pin number 5 changed.
Pages 140, 144, 145: Information on SV settings added.
Pages 433, 434, 435: Information added to tables in several places.
05 February 2002 Page 177: Ladder symbol removed.