Reinstall the Server Into the Rack
Use this procedure to install the server chassis with mounting brackets into the slide-rail
assemblies that are mounted to the rack.
Caution:
Personal Injury or Equipment Damage: This procedure requires a minimum of
two people because of the weight of the server. Attempting this procedure alone
could result in equipment damage or personal injury.
Always load equipment into a rack from the bottom up so that the rack does not
become top-heavy and tip over. Extend the rack anti-tilt bar to prevent the rack from
tipping during equipment installation.
1. To prevent the rack from tipping forward when the server is extended, extend all rack
anti-tilt mechanisms.
See Stabilize the Rack.
2. Push the slide-rails as far as possible into the slide-rail assemblies in the rack.
3. Position the server so that the back ends of the mounting brackets are aligned with the
slide-rail assemblies that are mounted in the rack.
4. Insert the mounting brackets into the slide-rails, and then push the server into the rack
until the mounting brackets are flush with the slide-rail stops (approximately 30 cm or 12
inches).
Chapter 6
Reinstall the Server Into the Rack
6-3
To Next Page
Loading...
Need help?
General