• Oracle Sun Rack II 1042 Documentation
Extend the Server to the Maintenance Position
The following components can be serviced with the server in the maintenance position:
• Fan modules
• Storage drives
• DDR5 DIMMs
• Processors
• M.2 Flash drives and risers
• System battery
• Motherboard
• PCIe cards and cables
• Disk backplane
• Front indicator module
If the server is installed in a rack with extendable slide-rails, use this procedure to extend the
server to the maintenance position.
1. To prevent the rack from tipping forward when the server is extended, extend all rack
anti-tilt mechanisms.
See Stabilize the Rack.
2. Verify that no cables will be damaged or will interfere when the server is extended.
Although the cable management arm (CMA) that is supplied with the server is hinged to
accommodate extending the server, ensure that all cables and cords are capable of
extending.
3. From the front of the server, open and hold the left and right release latch covers in the
open position.
When in an open position, the release latch covers engage the slide-rail release latches
[1].
Caution:
Deploy any rack anti-tilt mechanism before releasing the slide-rail release
latches.
Chapter 2
Preparing the Server for Component Replacement
2-13
To Next Page
Loading...
Need help?
General