Note:
Do not power on server nodes until the disks on the storage shelf
and storage expansion shelf have initialized.
2. If you powered off a server, performing the following actions:
a. Reconnect any unplugged power cords.
As soon as the power cords are connected, Standby power is applied. In
Standby power mode:
• The System OK LED on the server front panel blinks slowly.
• The SP OK LED indicator is steady on.
• The AC power supply LED indicator lights are steady on.
Depending on the firmware configuration, the system might boot. If it does
not boot, perform the following procedure.
b. Power on the server to Main power mode by performing one of the following
actions:
• Press the On/Standby button on the front bezel.
• Log in to the Oracle ILOM web interface, click Host Management →
Power Control, and select Power On from the Select Action list.
• Log in to the Oracle ILOM command-line interface (CLI), and type the
following command at the Oracle ILOM prompt:
-> start /System
When the server is powered on to Main power mode and the power-on
self-test (POST) code checkpoint tests are complete, the green System
OK LED status indicator on the front panel of the server lights and remains
lit.
Chapter 6
Powering On Oracle Database Appliance
6-14
To Next Page
Loading...
Need help?
General