range Pi User Manual Copyright reserved by Shenzhen Xunlong Software Co., Ltd
148
inet6 fe80::938f:8776:5783:afa2 prefixlen 64 scopeid 0x20<link>
ether 4a:a0:c8:25:42:82 txqueuelen 1000 (Ethernet)
RX packets 25370 bytes 2709590 (2.7 MB)
RX errors 0 dropped 50 overruns 0 frame 0
TX packets 3798 bytes 1519493 (1.5 MB)
TX errors 0 dropped 0 overruns 0 carrier 0 collisions 0
device interrupt 83
The IP of the device connected to the WIFI hotspot is also assigned by the main
router, so the mobile phone connected to the WIFI hotspot and the development board are
in the same network segment. At this time, click on the connected WIFI hotspot orangepi,
and then you can see the IP address of the mobile phone. Also 192.168.1.X.
6）Without specifying the --freq-band parameter, the hotspot created by default is in the
2.4G frequency band. If you want to create a hotspot in the 5G frequency band, you can
specify it through the --freq-band 5 parameter. The specific command is as follows
Note that in the following command, Debian12 needs to modify eth0 to end1.
orangepi@orangepi:~$ sudo create_ap --no-virt -m bridge wlan0 eth0 orangepi orangepi --freq-band 5
7）If you need to hide the SSID, you can specify the --hidden parameter. The specific
command is as follows
Note that in the following command, Debian12 needs to modify eth0 to end1.
To Next Page
Loading...