Four-Channel Digital Video Recorder
11
Chapter 3. Configuration
3.1 Overview
Your DVR provides a Graphic User Interface (GUI) for easy system programming and
operation. The front panel push-button controls are used to enter system commands and for
programming. A system video monitor must be connected to the video-out connector (BNC
or SVHS) to view the video and programming screens.
3.2 System Setup
Press
MENU
on the front panel to initialize the Quick Setup screen after confirming the setup
password. Refer to 3.8 Configuring Other Parameters ─ Enable/Disable Password
section for details of setting up the password. Disabling the Quick Setup and closing the
Quick Setup screen goes to the Normal Setup screen displaying the GUI with eight
programming icons (buttons) at the bottom. In the system setup mode, press
MENU
to exit
from the setup mode, and go to the live monitoring mode.
3.2.1 Quick Setup
As well as the Normal Setup, the DVR also supports the Quick Setup for system programming.
The factory default is the Quick Setup. In the Quick Setup mode, the user can program the
following options for each camera input:
• Quick Setup On/Off
• Recording Speed/Image Quality
• Audio Recording
• Sequence Dwell Time
• System Information
• Camera Selection & Titling
• Network Configuration (Network-supported Premium Model Only)
• Security (Password)
• Date/Time Initialization
To Next Page
Loading...
