Four-Channel Digital Video Recorder
33
Set up Event-driven Recording Schedule
0PATH: MENU ▶ Event Action ▶ Alarm-In Action, Motion Action, Text-In Action, or Video
0Loss Action0
(Refer to Figure 20, Figure 22, Figure 23, or Figure 24.)
1. Select the Event action from the event-driven recording options: alarm-in, motion detector,
text-in, or video loss.
2. Move to the Sched field(Schedule) of the selected event, and press
ENTER.
3. The recording schedule is configured from Sunday to Saturday and Holidays at 30-minute
intervals from 0:00 to 24:00.
4. Move to a specific hour of a specific day, and press
ENTER to select the record mode:
No Recording (no block), Mode 1(Blue block), or Mode 2 (Yellow block). Select
Mode 1 for normal record setup. For details of using Mode 2 refer to the Chapter 4.2
Recording.
5. To select multiple hours within a single day, move to a specific day in the left side and
press
ENTER to set the same setting to whole hours of that day. To select multiple days
with the same recording hours, move to the specific hour field at the top of the schedule and
press
ENTER to set the same setting to whole days of that hour.
6. Move to the empty block on the top left side, and press ENTER to set all days and hours to
the same setting.
NOTE: The interval of time setting is 30 minutes. Selecting the first blank means
From 00:00:00 to 00:29:59.
Set up Audio Recording
0PATH: MENU ▶ Devices ▶ Audio0
1. Move to the Audio field, and enable or disable the audio recording by selecting On or Off.
2. Move to the Mute field, and enable or disable the audio output by selecting On or Off.
NOTE: The DVR will NOT record audio when the recording speed is set to less 1 ips.
To Next Page
Loading...
