Panasonic AV-HS6000 - Setting the WFM;VECT of Menu Panel AV-HS60 C3

– 131 –
Chapter 8 System Menu — System settings
Setting the WFM/VECT of Menu Panel AV‑HS60C3
WFM and VECT which are displayed in Menu Panel AV-HS60C3 can be set.
@@
NOTE
t This function will be available in V2.00.00 or higher.
Setting the WFM (waveform monitor)
1
Select the <SYS> button → [SYSTEM] → [Display] tab.
2
Select an item in [Style] in the [WFM] column.
f Select the display method of the signal waveform.
[Parade] The signal waveforms are displayed side-by-side.
[Overlay] The signal waveforms are displayed on top of each other.
3
Select an item in [Mode] in the [WFM] column.
f Select the signal with the waveform displayed.
[YPbPr] Y, P
B
, and P
R
signals are displayed.
[RGB] R, G, and B signals are displayed.
[Y] Only the Y signal is displayed.
Setting the VECTOR (vectorscope)
The reference marker of the color bar can be selected.
1
Select the <SYS> button → [SYSTEM] → [Display] tab.
2
Select an item in [Bar Target] in the [Vector] column.
[75%] The reference marker of the 75% color bar is displayed.
[100%] The reference marker of the 100% color bar is displayed.