Panasonic AV-HS6000 - Startup Settings;Initialization

– 140 –
Chapter 8 System Menu — Maintenance settings
r Display details
[No Alarm] Shows that there are no problems.
[Alarm] Shows that there is a problem.
[−]
Not a target for determination.
f When a power supply unit is not mounted
f When [Off] is selected in each item of [Alarm Enable]
Enabling/disabling the alarm display
1
Select the <SYS> button → [MAINTENANCE] → [Alarm] tab.
2
Select an item in the [Alarm Enable] column below each [Main frame]/[Main Panel]/[Sub Panel1]/[Sub Panel2] column.
f The [Sub Panel1]/[Sub Panel2] columns will be available in V2.00.00 or higher.
[On] Alarm detection is enabled.
[Off] Alarm detection is disabled.
Log le recording
Each type of information in this unit such as alarms, are recorded in the built‑in log le.
The log le can be saved to a memory card.
1
Select the <SYS> button → [MAINTENANCE] → [Alarm] tab.
2
Select an item in [Log File] in the [Log] column.
f Select the le to be loaded from the le selection screen.
3
Select [OK].
f Save the log le to a memory card.
Startup settings/initialization
Startup settings
Set the status replicated when the power is turned on.
f The setting is xed with [Resume Data] in the version below V2.00.00.
1
Select the <SYS> button → [MAINTENANCE] → [Boot] tab.
2
Select [Resume Data] or [Project Data] in the [Boot Select] column
f Select the startup setting data.
[Resume Data] Selects the resume data. When power is turned on, the system starts using the settings from the previous power-off.
[Project Data]*
Selects the project data. When power is turned on, the project le specied in the step
3 onwards is loaded.
* This function will be available in V2.00.00 or higher.
3
Select an item in [From] in the [Project Data] column.
f Specify the storage location of the project le used during startup.
[SD] Specify the memory card.
[SSD] Specify the SSD.
4
Select an item in [Project] in the [Project Data] column.
f Specify the project le.
Initializing the setting data
The setting data can be reset to factory settings.
1
Select the <SYS> button → [MAINTENANCE] → [Boot] tab.
2
Select an item in the [Initial] column.
f Select the mode to be initialized.
[Initial] Data is initialized except plug-in software and network setting values.
[with Plugin]*
Data is initialized including plug-in software.
f Network setting values are not initialized.
[with Plugin/NW] Data is initialized including plug-in software and network setting values.
* This function will be available in V2.00.00 or higher.
3
Select [OK] in the confirmation screen.
f Initialize the settings data.