– 30 –
Chapter 4 Preparations — Turning power on/off
Turning power on/off
Turning power on
1
Set the <POWER> switches of the Main Frame AV‑HS60U1/AV‑HS60U2 and the Control Panel AV‑HS60C1/AV‑HS60C2 to <ON>.
f For the redundant power supply model (AV-HS60U2, AV-HS60C2), set both <POWER> switches of the power supply 1and the power supply 2 to
<ON>.
f The power indicator will light up when power is supplied.
Turning power off
1
Set the <POWER> switches of the Main Frame AV‑HS60U1/AV‑HS60U2 and the Control Panel AV‑HS60C1/AV‑HS60C2 to <OFF>.
f For the redundant power supply model (AV-HS60U2, AV-HS60C2), set both <POWER> switches of the power supply 1and the power supply 2 to
<OFF>.
f The power indicator will go off when power is cut off.
@@
NOTE
t Do not turn off the power when accessing the memory card or the Storage Module AV-HS60D1 (optional). Data in the memory card may be damaged.
t When set to [Resume Data] from the <SYS> button on the top menu → [MAINTENANCE] → [Boot] tab → [Boot Select] column, normally the unit will
start up with the settings as they were when power was cut off, except image data of the VMEM (video memory). (page 140)
Note that, in the following items, the changed settings will be backed up at approximately 60-second intervals in the non-volatile memory, and the
settings at the time of shutdown will be restored, but the settings changed within approximately 60 seconds before turning off the power may not be
updated. To update securely, do not change settings within approximately 60 seconds before turning off the power.
- Background wipe preset (This function will be available in V2.00.00 or higher.)
- Key source preset (This function will be available in V2.00.00 or higher.)
To Next Page
Loading...
