Panasonic FP-XH Series

5.5 Repeat Operation
5.5.1 Overview of Repeat Operation
● The repeat count is specified for executing the repeat control in Configurator PMX.
● When the position control start instruction F380 is executed, the unit repeats the operation
set in the positioning table.
■
Conditions of repeat control
Item Repeat control is available Repeat control is unavailable
Operation pattern
E-point control, P-point control + E-point
control
C-point control + E-point control
JOG operation, J-point control, Interpolation
control
Control method Increment mode Absolute mode
Dwell time setting
Set the table of E-point control to 1 ms or
more.
When setting 0 ms.
■
Operation diagram (Setting operation on the table)
■
Operation diagram (Repeat operation)
5.5 Repeat Operation
5-28 WUME-FPXHPOSG-01