Panasonic FP-XH Series

■
Configurator PMX settings
■
Sample program
The execution condition is differential execution. For details of instructions, refer to
"7 Instruction References".
5.5.3 Stop Operation During Repeat Operation
● When setting the repeat function, the operation at the time of deceleration stop varies as
follows.
■
Operation at the time of deceleration stop (Repeating E-point control)
When the unit detects a deceleration stop, the unit will come to a stop after repeating
positioning control N+2 times. However, the unit will stop the control when reaching the set
repeat count.
5.5 Repeat Operation
WUME-FPXHPOSG-01 5-31