, : Dial Pause (default 1 s)
; : Dial Pause (default 3 s)
X: Extension Dialling
0–9, , #: Dial Code
Maintenance Console Location
24.4 UM Configuration—[5-4] System Parameters—Parameters
PBX Environment—Alternate Extension Transfer Sequence (Up to 16 digits /
[0-9 * # D R F T X , ;])
Specifies the sequence for transferring calls to extensions in the Alternate Extension Group.
Value Range
Max. 16 digits consisting of 0–9,
, # and special codes
D: Disconnecting
F: Flash (Recall)
R: Ringback Tone Detection
T: Dial Tone Detection
, : Dial Pause (default 1 s)
; : Dial Pause (default 3 s)
X: Extension Dialling
0–9, , #: Dial Code
Maintenance Console Location
24.4 UM Configuration—[5-4] System Parameters—Parameters
Feature Guide References
3.2.1.1 Alternate Extension Group
Dialling Parameters/MSW Notification
Dialling Parameters—Call Transfer No Answer Time (10-60 s)
Specifies the length of time that the system waits before retrieving the transferred call when there is no answer
at the destination extension.
Note
Make sure that the duration of Call Transfer No Answer Time is longer than the duration of Call Forwarding
No Answer Time at the PBX. Otherwise, the PBX may forward the call immediately to the extension’s
Intercept Routing destination according to PBX programming, rather than return the call to the system.
Value Range
10–60 s
Maintenance Console Location
24.4 UM Configuration—[5-4] System Parameters—Parameters
954 PC Programming Manual
24.4 UM Configuration—[5-4] System Parameters—Parameters
To Next Page
Loading...
