17-00001-C Page | 125
Flight Tube: Care & Maintenance
• Dirt, grease, debris builds
up over time in the tubes.
• It is recommended to
blow out flight tube after
each tool change.
• 1
st
: Detach tube(s) from
MAS 350 Module and
upper tool changer.
• DO NOT use rubbing alcohol, WD-40, diesel, gas, etc., to rinse out inside of flight
tubes!
• DO NOT use Silicone Spray as a lubricant on this machine.
• 2
nd
: Use dry compressed air to
blow out debris.
• Eye protection must
be worn.
• 3
rd
: Rinse inside of tube with
Denatured Alcohol and air dry.
• Read all warnings
on cleaning solution
container & follow
recommendations for safe
handling and storage.
To Next Page
Loading...