PennEngineering Haeger 824 WindowTouch-4e - Upper Tool Holder: Care & Maintenance

17-00001-C Page | 127
Upper Tool Holder: Care & Maintenance
DO NOT use rubbing alcohol, WD-40, diesel,
gas, etc., to clean contacts or any part of the holder!
• It is recommended to
inspect the upper tool
holder and its contacts
weekly or more
frequently based on
usage.
• 1
st
: Turn round thumb screw
counter clockwise to allow tool
holder to slide off.
• 2
nd
: Inspect springs and
contacts and wipe off with
clean dry cloth.
• 3
rd
: Wipe off all metallic areas
with clean dry cloth.
• 4
th
: Wipe inside of tool holder
with clean dry cloth.
• 5
th
: Apply a THIN FILM of
on metallic areas
only.
• 6
th
: Re-install springs with
metal contactors in body of
tool holder, slide body over
sensor and tighten thumb
screw.
• DO NOT use
Silicone Spray
to lube inside
of holder.
• If necessary,
can be applied
to a clean cloth
to remove dirt
and grease.