PennEngineering Haeger 824 WindowTouch-4e - Input 1: Station; Input 2: Material; Input 3: Fastener

17-00001-C Page | 58
To program a Quick Run operation you will follow the easy programming wizard using the steps.
7.
Input 1: Station
8.
Input 2: Material
9.
Input 3: Fastener
• Select Station.
• Touch on Station 1
• Select Fastener Material.
• Touch on Steel
• Select Fastener.
• Touch on Stud/Pin
1. Station: Station is a high
volume, Automatic insertion station
working in conjunction with Modular
Automated Feed System (MAS).
Stations are Manual
tooling/Manual feed insertion stations.
2. Material:
➢ Aluminum
➢ Steel
➢ Stainless
➢ Copper
3. Fastener:
➢ Nut
➢ Standoff
➢ Stud/Pin
➢ Blind standoff