Do not operate the machine without both the Upper and Lower
Tools properly locked in place with the correct set screws
and/or Quick Change Lever.
The Lower Tool Holder is secured to the lower arm of the machine’s frame by a M16 X 50SHCS (Socket
Head Cap Screw). When this cap screw is loosened, the lower tool may be aligned to the upper tool. All
Standard Haeger Lower Tools fit in the Lower Tool Holder without the need for any adapters.
To loosen or tighten the M16 X 50 SHCS you must turn the turret tool to gain access.
To align the Turret Tool:
1. Bring Upper tool down to just above lower turret with tool installed for alignment.
2. Turn the lower turret tool to gain access to the M16 X 50 SHCS.
3. Loosen the M16 X 50 SHCS and use the M16 X 60 SHCS on the back of the turret tool to move
assembly forward or back.
4. Use the Side adjustment screws to align turret from side to side. .
5. Once alignment has been set Tighten the Hold down bolt M16 X 50 SHCS To 90 ft./ lbs.
Steps to Install a Lower Tool
1. Turn Turret to allow bolt to be put in under the turret tool arm.
2. Place the tool into the Lower Tool Holder.
3. Lock the tool into place in the Lower Tool Holder by
tightening the bolt until the tool is locked securely in
place.
To Next Page
Loading...