Vacuum: This feature allows for the
operator to switch ON or OFF the vacuum
system during the use of automatic tooling
with upper vacuum anvil.
Tooling: This feature allows the operator to
select the type of tooling to run in the
selected station.
Tooling Options are: Shuttle, Manual
and Bottom Feed
Modular Auto Feed System (MAS): This
feature allows the operator to either run
the MAS 350 at a continuous vibration or an
intermittent vibration. Continuous vibration
is commonly used when running the bowl
out of hardware for a tooling change or for
those small quantity hardware runs.
Intermittent vibration is most commonly
used for normal insertion applications
where you have good quantity of hardware
that will keep your multi module full at all
times.
• MAS
• Touch on to vibrate fasteners up to
position, ready to be ejected
To Next Page
Loading...