17-00001-C Page | 18
Machine setup
1. Carefully locate the machine in the shop on a flat and preferably level hard surface such able to
with withstand the weight of the machine as described it the “Basic Data” paragraph of this
manual. If there is any question on the ability of the sub-surface to support the weight of the
machine, check with a structural engineer. As of this publication there are no know
requirements for fixing or anchoring the machine to the sub-surface, check with your local
building code official, agency or structural engineer in your area to verify.
2. Level it front to back and left to right using the top surface of the Lower Tool Holder as a
reference surface (see Figure below) Using a 7/8 in./22 mm wrench to adjust the feet, level the
machine left to right and front to back. Make sure that all of the machine’s feet are securely
resting on the shop floor.
3. Without changing the height adjustment of the feet, tighten the lock nut on each foot using a
15/16 in./24 mm wrench.
To Next Page
Loading...