PennEngineering Haeger 824 WindowTouch-4e - Another Setup Stroke Is Required after Adjustments

17-00001-C Page | 99
119.
120.
121.
Another Setup Stroke Is Required After Adjustments
Fastener Data is displayed as
programmed.
Increase or decreased by touching
the or symbols on either
side of the value shown. Or touch
on the value itself, to touch
type a new value.
Check the specifications for your fastener
to determine the appropriate force to use
Another setup stroke is required to
verify adjustments are acceptable.
• Programmed
values
• Adjust Values as
shown
• Run another Setup Stroke
with new values
• Touch on OK