98
Shooting Functions
4
• By default, you cannot adjust the focus with the remote control unit. Focus on
the subject first with the camera before operating with the remote control unit.
When [9. AF with Remote Control] is set to [On] in the [A Custom Setting 2]
menu, you can use the remote control unit to adjust the focus.
• Select a mode other than h, i or i in the Drive Mode setting screen to
cancel the remote control shooting. The setting is canceled when the camera
is turned off if [Drive Mode] is set to P (Off) in [Memory] of the [A Rec. Mode
3] menu. (p.189)
• The Shake Reduction function is automatically turned off when h, i or i
is set.
• The remote control shooting may not be available in backlit conditions.
• When using the Remote Control Waterproof O-RC1, the autofocus system
can be operated with the S button. The { button cannot be used.
• The Remote Control F can send a remote control signal about 30,000 times.
Contact a PENTAX Service Center to replace the battery (this will involve a
fee).
To Next Page
Loading...
