88
Shooting Functions
4
You can set the camera to perform focusing by pressing the d/i button.
Use this setting when activating the autofocus by pressing the shutter
release button halfway is not desired.
First, assign the Enable AF function to the d/i button.
1
Select [Green Button] in the [A Rec. Mode 3] menu, and
press the four-way controller (5).
The [Green Button] screen appears.
2
Press the four-way controller
(5), use the four-way controller
(23) to select [Enable AF], and
press the 4 button.
3
Press the 3 button twice.
Enable AF is assigned to the d/i button and the camera is ready to take
a picture.
4
While viewing the subject on the
monitor, press the d/i button.
The autofocus system operates.
Focusing Using the d/i Button
• When Enable AF is assigned to the d/i button, the autofocus by pressing
the shutter release button halfway is disabled.
• If Enable AF is assigned to the d/i button when the capture mode is set to
u (Blur Control) mode or w (Quick Macro) of H (Scene) mode, use the
d/i button to make sure before shooting that a subject is in focus. The
desired blur effect cannot be achieved if the subject is not in focus.
To Next Page
Loading...
Need help?
General
