Philips iE33 - Deleting Voice Profiles; Background Noise; Communication Problems

Deleting Voice Proles
You can delete voice profiles that are no longer needed. If you are not satisfied
with the training you have done so far, you can delete that voice profile and start
training a new profile from the beginning.
1. Press the Setup key.
2. Click Voice Control.
3. Select the profile that you want to delete, and then click Delete Voice
Profile.
4. To delete other profiles, repeat step 3.
5. Click Done.
Background Noise
Background noise in the exam room can interfere with your use of voice control.
Fans, patient monitors, voice paging, and even Doppler audio on the system can
lower the accuracy of voice recognition. If you are going to be using voice control,
it is helpful to reduce or eliminate noise by turning off loud equipment and by
limiting the volume level of Doppler audio.
Communication Problems
The voice control feature uses Bluetooth wireless technology. This technology
is also commonly used in cellular telephones and other wireless applications. To
prevent other Bluetooth devices from sending unintended commands through
voice control to the system, the system listens only to headsets that have been
paired and connected to it.
On rare occasions, a nonstandard wireless device operating near the system
may disrupt communications between the voice control headset and the system,
but will not execute commands on the system.
If you cannot communicate with your system using the voice control headset,
first perform the steps in "Troubleshooting Voice Controls" on page 159. If the
iE33 User Manual
158
4535 616 23901
Using the System
5