• To acquire a single image, press Freeze and then press Acquire.
• To acquire a cineloop sequence, press Acquire in live imaging or while
reviewing a cineloop sequence. Acquisition during live imaging saves
prospective or retrospective frames, as specified in Live Capture Type in
the setups. A prospective capture captures a specified acquired loop length.
A retrospective capture captures a loop that ends when Acquire is pressed.
Acquisition while reviewing a cineloop sequence saves all retrospective frames
in the cineloop sequence.
NOTES
• During acquisition, a spinning hourglass icon displays at the bottom of the
display. When the acquisition is complete, a thumbnail of the image is
displayed.
• When an image is acquired, you will hear a beep to confirm that the loop
or image was saved in the patient's study. Do not press Review until you
hear the beep.
• If you press Acquire in a non-simultaneous mode while a live M-mode or
Doppler trace is active, you acquire a cineloop sequence. If you press
Acquire in a simultaneous mode, you acquire a single image.
• If you attempt to acquire a loop that was imported from media, only a frame
of the loop is acquired and displayed in the appending exam.
Measurement and Analysis
A calculations package contains one or more collections that organize groups,
measurements, and calculations into a coherent tool for diagnostic analysis.
Measurement tools provide measurements and derived calculations. Various
methods are available for generating results. The two primary methods allow
you to “measure then label” or “label then measure.” Either way, the results can
appear on the display, on printed pages, and in patient reports, where they are
available for your analysis.
In the setups is an analysis configuration capability that allows you to create your
own calc lists including collections, groups, measurements, and calculations. In
201
iE33 User Manual
4535 616 23901
7
Performing an Exam
To Next Page
Loading...