4. Touch a group label if a set of associated measurements are required. A group
label opens to display multiple measurement labels.
5. Touch a measurement label and make the measurement. First, the caliper or
trace tool appears on the display. Then, as you make the measurement, the
results and derived calculations appear in the Results box and are
simultaneously added to the patient report.
6. For each measurement label within a group, touch a label and make the
measurement.
7. Touch End Measure. You can also press Select or Enter to complete the
measurement.
NOTE
The measurement automatically completes if you unfreeze the image, change
modes, or enter a report.
Obtaining a Calculation Result
Calculations are organized in collections for the applications included in the
system. The system uses measurement values to make calculations and create
a patient report. For more information regarding on using calculations, refer to
Help on your system.
The calculations in the system are based on medical references, which are listed
in the Help.
1. Obtain the image you want to measure and press Freeze.
2. Touch Analysis to display the collections, groups, and measurement controls
on the touch screen.
3. Touch a collection control, a group control, and a measurement control.
4. Make the measurement.
5. Touch End Measure or press Select, if necessary, to complete the
measurement. The measurement result appears below the measurement label.
6. To display the patient report, press Report. To edit the report, click Edit
Report, make changes, and click Close Report to save your changes.
203
iE33 User Manual
4535 616 23901
7
Performing an Exam
To Next Page
Loading...