Rotating the S7-2omni and the X7-2t Image Plane
You can rotate the image plane on the TEE transducer to achieve a 360-degree
view of the heart. You can use either the image plane rotation buttons on the
transducer handle or the controls on the Preset/Transducer touch screen.
Rotation stops when you release either button.
An icon shows the current degree of rotation. Depending on image orientation,
the icon appears in the upper or lower part of the display. Because the center
of the plane is the pivot point, you can achieve a 360-degree view
NOTE
The X7-2t transducer is capable of turning 360 degrees.
1. To rotate the X7-2t transducer image plane by using system controls, do one
of the following:
• Press the image plane rotation button that is distal to the system to rotate
the imaging plane toward the 180-degree position.
• Press the button that is proximal to the system to rotate the imaging plane
toward the 0-degree position.
2. To rotate the S7-2omni transducer image plane by using system controls, go
to the Preset/Transducer touch screen and do any of the following:
• Touch Up to rotate the imaging plane toward the 180-degree position.
• Touch Down to rotate the imaging plane toward the 0-degree position.
• Turn Seek Angle to set an angle and touch Seek to go directly to the
specified angle.
3. To rotate the X7-2t transducer image plane by using system controls, turn
Seek Angle to go directly to the specified angle.
iE33 User Manual
260
4535 616 23901
Transesophageal Transducers
10
To Next Page
Loading...