Philips iE33 - Acquiring Images and Loops

DVD to the hard drive may not have thumbnails if the images they contain are
no longer in their native format.
1. Touch Layout on the left touch screen to select the layout you want to use
to display images.
2. Do any of the following:
• Press Pointer, if necessary, and then click or to move up or down
through available thumbnails one or two images at a time.
• Drag the scroll bar to move up or down through available thumbnails
quickly.
• Turn Page to move backward or forward through the available images,
one page at a time.
• To view a single thumbnail in its original format, double-click it. (If the
image represents a 3D data set, it opens in 3D review mode.)
• To view multiple thumbnails in their original format, select the thumbnails
by clicking inside each one (not in its numbered box), then double-click
one of them. If the images displayed do not fit on one page, turn Page to
view them.
• Touch Exit Thumbnail Review to return to the Review Exam display.
Acquiring Images and Loops
You can acquire and save a single frame or a cineloop sequence. The acquired
frame or cineloop sequence is saved in the patient study, and a thumbnail of it
is available in the live imaging display and the Review display. Images are
automatically exported across the network either when you acquire or print an
image, or when you end an exam, depending on your selection for Send
Images/Clips on the Printer/Capture tab in the Print/Network setups.
Use the Freeze control to stop and start system image acquisition and update.
Pressing Freeze results in the system entering cineloop pause and assigning the
trackball to manual cineloop review (frame-by-frame).
Do one of the following:
iE33 User Manual
200
4535 616 23901
Performing an Exam
7