Philips iE33 - Product Compatibility

• Do not use solvents, such as thinner or acetone, or abrasive cleaners on
the system, transducers, or any hardcopy device.
• For optimal performance, connect your ultrasound system to a circuit
dedicated solely for the system. Do not connect life-support devices to the
same circuit as the ultrasound system.
• If systems, transducers, and peripherals have been in an environment below
10°C (50°F), allow them to reach room temperature before connecting or
turning them on. Philips recommends allowing 24 hours for complete
normalization. Otherwise, condensation inside the devices could cause
damage. If the device was only briefly exposed to temperatures below 10°C
(50°F), then the time required for the device to return to room temperature
could be significantly less than 24 hours.
• To avoid damaging the flat-panel display in the monitor, do not store the
system where the ambient temperature exceeds 65°C (149°F).
Product Compatibility
Do not use your system in combination with other products or components,
unless Philips expressly recognizes those other products or components as
compatible. For information about such products and components, contact your
Philips representative.
Changes and additions to the system should be made only by Philips or by third
parties expressly authorized by Philips to do so. Such changes and additions must
comply with all applicable laws and regulations that have the force of law within
the jurisdictions concerned, and best engineering practices.
WARNING
System changes and additions that are made without the appropriate training or
by using unapproved spare parts may void the Philips warranty. As with all
complex technical products, maintenance by unqualified persons or using
unapproved spare parts carries serious risks of system damage and personal
injury.
iE33 User Manual
34
4535 616 23901
Safety
2