5. Remove the transducer from the sterilization solution after the recommended
sterilization time has elapsed.
6. Using the instructions on the sterilization label, rinse the transducer in sterile
water up to the point of immersion, and then air dry or towel dry with a
sterile cloth.
7. Examine the transducer for damage, such as cracks, splitting, fluid leaks, or
sharp edges or projections. If damage is evident, discontinue use of the
transducer, and contact your Philips Ultrasound representative.
Immersing Transducers
Immerse this section only, up to 5.1 cm (2 in) from the connector’s strain
relief.
1
This is the maximum allowable immersion depth; you are not required
to immerse to this depth if it is not necessary.
2
319
iE33 User Manual
4535 616 23901
11
Transducer Care
To Next Page
Loading...