AXC 3050
76
PHOENIX CONTACT 8686_en_01
Controller context menu in
Diag+
The controller context menu in Figure 4-40 offers options for influencing the state of the
Axioline F local bus.
Figure 4-40 Controller context menu
The following menu items can be selected:
Refresh Refreshes the view in the “Diag+” dialog box.
Reset bus Resets the local bus. After being reset, the local bus is in
the READY state. The D LED lights up yellow (Table 2-1 on
page 21).
Stop bus Stops cyclic updating of the process data. The local bus is
then in the ACTIVE state. The LED flashes green.
Start bus If a valid configuration frame has been generated, the local
bus can be started using this menu item. The local bus is in
the RUN state after starting. The D LED is green. The pro-
cess data is updated cyclically after the local bus is started.
Create configuration Generates a valid bus configuration with the Axioline mod-
ules connected to the controller.
NOTE:
The process data is no longer updated.
NOTE:
The process data is no longer updated. The
Axioline F local bus continues running. A data
exchange is performed with invalid process da-
ta.
NOTE:
The process data is updated again.
To Next Page
Loading...
Need help?
General
