Previous Page Table of Contents Section Contents
Back
Index Next Page
LIFEPAK 500 automated external defibrillator Replacement Procedures
11-18
Replacing Case Page 2 of 2
The procedure for replacing the case is a composite of the following procedures.
It is recommended that you perform them in the order given.
Note: The procedures overlap to some degree. In the course of following the
procedures, you can replace assemblies as needed.
1. Preparing Lower Case for Replacement
2. Preparing Top Cover for Replacement
3. Removing Main PCB—Monophasic AED or Removing Main PCB—
Biphasic AED
4. Replacing Battery Plate Wire Harness
5. Replacing Speaker Assembly
6. Replacing Wave Shaping Inductor—Monophasic AED or Replacing
Inductive Resistor—Biphasic AED
7. Removing Energy Storage Capacitor—Monophasic AED or Removing
Energy Storage Capacitor—Biphasic AED
8. Replacing Patient Connector Harness—Monophasic AED or Replacing
Patient Connector Harness—Biphasic AED
9. Replacing Lower Enclosure Perimeter Seal
10. Removing Biphasic PCB—Biphasic AED
To Next Page
Loading...
