Caution:
Changes or modifications to this equipment not expressly approved by the party
responsible for compliance could void the user’s authority to operate the equipment.
This equipment contains an FCC approved radio frequency transmitter. An FCC ID number can be
found on the equipment label. This device and its antenna must not be co-located or operating in
conjunction with any other antenna or transmitter. The antenna(s) used for this transmitter must be
installed to provide a separation distance of at least 20 cm from all persons and must not be co-located or
operating in conjunction with any other antenna or transmitter.
Canada
This equipment contains an Industry Canada approved radio frequency transmitter. An IC certification
number can be found on the equipment label. The separation distance between the user of this
equipment and the transmitting device must be greater than 20cm to ensure compliance with radio
frequency exposure requirements. This transmitting device complies with Industry Canada license-
exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not
cause interference, and (2) this device must accept any interference, including interference that may
cause undesired operation of the device.
Japan
This equipment contains a radio frequency transmitter that has been certified for construction design
based on regulations in Radio Law Article 38, Section 24 and the technical specifications in Certification
Ordinance Article 2, Section 1, No. 19, 19-3, and 19-3-2. The certification mark and number is shown on
the equipment’s label.
Brazil
This equipment contains a radio frequency transmitter that has been certified for construction design
based on the General Telecommunications Law and the Radio Law Resolution 242 – General
Regulations on the Certification and Approval of Telecommunication Products. The ANATEL
certification mark is shown on the equipment’s label.
Safety
Pitney Bowes Operator Guide June 2018 15
To Next Page
Loading...
